Digi-Sense Type K Manual de Instruções descarregar pdf (Página 7)

Instruction Manual Type K Thermocouple Thermometer

2.5 Battery Replacement

A “LO” annunciator in the LCD alerts you when battery power is running low.

Replace with the same type as recommended by the manufacturer.

Figure 5: Low battery indicator

Caution: Power off the meter when changing battery.

2.6 Connecting the Temperature Sensor

Insert the yellow 2-pin mini connector plug of the temperature sensor into the

connector socket on the side of the meter.

NOTE: The negative pin is larger than the positive pin, be sure to properly align the

pins. Remove sensor from meter for long periods of non use.

Figure 6: Connecting the temperature sensor

2.7 Switching the Meter On

1. Press ON/OFF key to power up your meter. The

meter will momentarily display its revision

number and the whole LCD segments before

switching to the measurement mode.

2. The LCD displays “oPEn” if the temperature

sensor is faulty, or there is an open circuit, i.e. no sensor is attached. Please

refer to section on Troubleshooting if in doubt.

Figure 7: "Open" annunciator

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Sem comentários

Digi-Sense Type K Manual de Instruções Página 7